Garage Door Tension Cable Loose

Automatic garage door openers make getting in and out of your garage easy although the machinery does require periodic maintenance to ensure proper operation.

Garage door tension cable loose.

In this system the cables still do the lifting while the springs still provide the counter balance or force to open and close the garage door. Your garage door opens when the springs apply the right amount of tension to the cables. Here are a few reasons a cable may malfunction. Cables can also come off the pulley because of loose spring tension.

The garage door tension springs provide lifting force for the heavy door and are under tremendous tension get careless and they can hurt you. Repairing garage cable problems when a garage door cable comes off the pulley the tension on the pulley must be first released and then restored. What causes a cable drum slip. When adjusting your garage door cables keep in mind that if you loosen the shaft too much the cable can unwind and become tangled.

Properly functioning cables lift the door and spool on the drums. If the tension is too loose the springs that help lift the door are ineffective and the weight of. A loose garage door cable is not difficult to deal with but you will need a few key tools to tighten it properly. When you reengage the automatic opener the spring will put tension on the cable and tighten them further.

It s also important to remember that when you go to tighten the shaft only tighten until all the slack is gone from the cable. You need proper tension on a garage door to operate the door by hand or with an automatic opener. If that happens the cable may appear loose. When the door is open there will be plenty of slack you can use to wind a loose cable back around the pulley.

If you use the correct tools and follow our instructions you can rebuild the entire torsion spring system in just a few hours without any side trips to the er. If your cable are loose this could lead to a. If the cable comes loose it can affect how well the door functions and can cause it to not close fully.