How To Remove Rear Door Panel On 2004 Chevy Suburban

2004 suburban rear doors and tailgate wont unlock with buttons.

How to remove rear door panel on 2004 chevy suburban.

Do the same to all the snaps. Remove the trim panel upper extension. Raise or lower the rear of the seat cushion by raising or lowering the rear edge of the horizontal control. Place the common screwdriver at the top of the panel in between the door panel and the door.

Remove the trim panel from the door carefully sliding the trim panel up to release the retainers from the door. Remove door lock solenoid and plug it into another door to see if it works 2. Remove the door handle bezel. My 2003 chevy suburban door locks for the 2 rear doors and the tail gate door do not work properly.

Moving the whole horizontal control up or down. Remove the door panel using the common screwdriver. There are snaps on all three sides of the panel. Hello here is the instructions for removing the door panel.

Remove the courtesy light remove door panel screws. Also look on side of door for possible child saftey lock switch. But there are 2 relays located in the i p fuse panel 1 is for lock 1 is for unlock. Remove the window handle.

Remove the speaker wire. Pull drivers rear door panel off 1. Slide the screwdriver down until it contacts the snap and pry the snap out of the recess in the door. Remove the power accessory switch panel.

Remove the trim panel screws.